User Manual

221
Appendix A
Setting Levels Diagram
This diagram shows all of the setting levels. To move to the advanced function setting level and calibration
level, you must enter passwords. Some parameters are not displayed depending on the protect level setting
and the conditions of use.
Control stops when you move from the operation level to the initial setting level.
Note (1) Moves to operation level by software reset.
(2) It is not possible to move to other levels from the calibration level by operating the keys on the front
panel. It can be done only by first turning OFF the power.
(3) From the manual control level, key operations can be used to move to the operation level only.
(See
note
3.)
(See
note 1.)
(See
note 2.)
Power ON
Started in manual mode.
Manual
mode
Press the O Key
for at least 1 s.
Press the O Key for
at least 1 s; display
will flash.
Press the Ol Key for
at least 3 s while a-m
is displayed.
Manual Control
Level
Operation Level
Press the
O Key
for at
least 1 s.
Initial Setting Level
Press the O Key
for at least 1 s.
Advanced Function
Setting Level
Calibration Level
Input password.
Set value 1201
Input password.
Set value −169
Press the
O Key less than 1 s.
Communi-
cations Set-
ting Level
Press the O Key for at
least 1 s; display will flash.
Press the O Key for at
least 3 s.
Control stops.
Press the
O Key for less than 1 s.
Adjustment Level
Press the O
+ M Keys for
at least 1 s.
Press the O +
M keys; display
will flash.
Press the O +
M Keys for at
least 3 s. (See
note.)
Protect level
Note: The time taken to move
to the protect level can
be adjusted by chang-
ing the "Move to pro-
tect level time" setting.
Control in progress
Level change
Not displayed for some models
Control stopped
Started in automatic mode.
a-m
C
25
100
C
25
100
C