User Manual

180
Advanced Function Setting Level Section 5-7
• This parameter sets the function to be assigned to alarm output 3.
Note (1) If c-o is assigned for standard control, a value equivalent to 0% will be
output.
(2) Can be selected only when the program pattern is not set to OFF.
(3) If the “standard or heating/cooling” parameter is set to heating/cooling
control when there is no control output 2 (E5AN/EN), control automatical-
ly switches to c-o.
■ Related Parameters
Standard or heating/cooling: Page 150, Program pattern: Page 151, (initial
setting level)
• This parameter switches the characters to be displayed.
The following two types of characters can be displayed.
11-segment display
7-segment display
When set to on, an 11-segment display is used.
alm3 Alarm 3 Assignment
Alarm output 3 must be assigned
(E5AN and E5EN only).
Setting range Default
none: No function is assigned to alarm output 3. alm3
(See note
3.)
o: Heating control output is output.
c-o: Cooling control output is output. (See note 1.)
alm1: Alarm 1 is output.
alm2: Alarm 2 is output.
alm3: Alarm 3 is output.
p.end: Program end is output. (See note 2.)
Function
Setting
See
See
csel Character Select
Setting range Default
on: 11-segment display, off: 7-segment display on
Function
Setting