User Manual

169
Advanced Function Setting Level Section 5-7
• .This parameter switches the logic of the MB command (communications
writing switch) for the SYSWAY communications protocol
• The MB command (communications writing switch) is the equivalent of
the MB command (remote/local switch) of the E5@J.
• The setting indicated by the shaded area is the default (same logic as
E5@J).
(Terms in parentheses () are the terms used on the E5@J.)
■ Related Parameters
Communications writing (adjustment level): Page 131
Protocol setting (communications setting level): Page 182
Use the PV color change function to change the color of the PV display (No. 1
display).
There are three display colors, orange, red, and green, and you can select
from the following three modes and eight types.
• Constant: This mode displays orange, red, or green all the time.
• Linked to Alarm 1: This mode switches the PV display color from red to
green when alarm 1 turns ON or from green to red when alarm 1 turns
ON.
• Linked to PV stable band: This mode switches the PV display color
between red outside the PV stable band and green within PV stable band,
or between green outside the PV stable band and red within PV stable
band. Set the PV stable band in the “PV stable band” parameter in the
advanced function setting level.
• The default is red (red).
The following table shows the display functions that can be set using the PV
color change function.
rlrv MB Command Logic Switching
Communications must be supported.
CompoWay/F must be selected as
the protocol.
Set
value
Text data of MB command
0000 0001
OFF Communications writing enabled
(remote mode selection)
Communications writing disabled
(local mode selection)
ON Communications writing disabled
(local mode selection)
Communications writing enabled
(remote mode selection)
Function
Setting
See
See
colr PV Change Color
Function
Setting
Mode Setting Function PV change color Application example
Constant org Orange Constant: Orange To match the display color
with other Controller models
red Red Constant: Red To match the display color
with other Controller models
grn Green Constant: Green To match the display color
with other Controller models