User Manual

125
Operation Level Section 5-3
■ Related Parameters
Input type: Page 146, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 148 (initial setting level)
Alarm 1 type (initial setting level): Page 152
Standby sequence reset: Page 161, Alarm 1 open in alarm: Page 162, Alarm
1 hysteresis: Page 163, Alarm 1 latch: Page 167 (advanced function setting
level)
This parameter is set to one of the input values “X” in the alarm type list.
• This parameter sets the alarm value for alarm output 2.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the “decimal
point” parameter setting.
■ Related Parameters
Input type: Page 146, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 148 (initial setting level)
Alarm 2 type (initial setting level): Page 154
Standby sequence reset: Page 161, Alarm 2 open in alarm: Page 162, Alarm
2 hysteresis: Page 163, Alarm 2 latch: Page 167 (advanced function setting
level)
This parameter is set to one of the input values “X” in the alarm type list.
• This parameter sets the alarm value for alarm output 3.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the “decimal
point” parameter setting.
See
See
al-2 Alarm Value 2
Alarm 2 must be assigned.
The alarm 2 type must be set to
other than an upper and lower limit
alarm.
Setting range Unit Default
−1999 to 9999 EU 0
Function
Setting
See
See
al-3 Alarm Value 3
Alarm 3 must be assigned.
The alarm 3 type must be set to
other than an upper and lower limit
alarm.
Setting range Unit Default
−1999 to 9999 EU 0
Function
Setting