User Manual

124
Operation Level Section 5-3
• This parameter measures and displays the remaining time of the soak
time for the simple program function.
■ Related Parameters
Program start (operation level): Page 123
Soak time, Wait band (adjustment level): Page 141
Program pattern (initial setting level): Page 151
Soak time unit (advanced function setting level): Page 181
This parameter starts and stops the control operation.
When run (RUN) is selected, control is started. When stop (STOP) is
selected, control is stopped. The STOP indicator will light when control.
The default is run.
This parameter will not be displayed if an event input is set to “RUN/STOP.”
This parameter is set to one of the input values “X” in the alarm type list.
• This parameter sets the alarm value for alarm output 1.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the “decimal
point” parameter setting.
sktr Soak Time Remain
The “program pattern” parameter
must not be set to OFF.
Monitor range Unit
0 to 9999 min or h
Function
Monitor
See
See
r-s RUN/STOP
The run/stop function must not be set
for the “event input assignment 1/2”
parameter.
Function
See
See
al-1 Alarm Value 1
Alarm 1 must be assigned.
The “alarm 1 type” parameter must
not be set to an upper/lower limit
alarm and a loop break alarm must
not be set.
Setting range Unit Default
−1999 to 9999 EU 0
Function
Setting