User Manual

105
Using the Simple Program Function Section 4-15
Program Pattern Either of two program patterns can be selected. The simple program opera-
tion will not be performed if the “program pattern” parameter is set to OFF.
■ Pattern 1 (STOP)
Control will stop and the STOP mode will be entered when the program has
ended.
■ Pattern 2 (CONT)
Control will continue in RUN mode when the program has ended.
The pattern display and setting range will change as shown in the following
table when a program mode is set in the “program pattern” parameter.
RSET → STRT
PV
Set point
Wait band
Wait band
Soak time END display
END output
Automatically switches
from RUN to STOP mode.
Item Program mode not selected Program mode selected
Displayed parame-
ters
There are no parameters that
are not displayed if a program
mode is set.
• Program start
•Soak time
• Soak time unit
• Wait band
• Soak time remain
Control output 1/2
assignment
Alarm 1/2/3 assign-
ment
Setting range
Not assigned.
Control output (heating)
Control output (cooling)
Alarm 1
Alarm 2
Alarm 3
Not assigned.
Control output (heating)
Control output (cooling)
Alarm 1
Alarm 2
Alarm 3
Program end output
Event input assign-
ment 1/2 setting
range
Not assigned.
RUN/STOP
AUTO/MANUAL
Not assigned.
RUN/STOP
AUTO/MANUAL
Program start (RESET/
START)
RSET → STRT
PV
Set point
Wait band
Wait band
Soak time END display
END output
RUN mode continues.