Brochure

Precautions
51
Heat-resistant fibers
• The fiber connector E39-F10 cannot be used for extension.
E32-T14/E32-G14
The presence of a reflective object at the front ends
of the lenses may place the unit in an incident state.
In this case, apply the supplied black stickers to the
front ends of the lenses.
Supplied slit for E32-T16
When using the supplied slit, peel off the back paper
and apply it along the outline of the sensing surface.
The slit is recommended in applications where satu-
ration occurs.
E32-M21
To prevent mutual interference sufficient distance
between the four sensing heads has to be ensured.
Adjustment
E32-G14
Due to the short distance between the sensor heads, two-point teaching (with and
without object) is recommended.
Accessories
Protective Spiral Tubes
1. Insert a fiber to the protective spiral tube from the head connector side (screwed)
of the tube.
2. Push the fiber into the protective spiral tube. The tube should be straight so that
the fiber is not twisted when inserted. Then turn the end cap of the spiral tube.
3. Secure the protective spiral tube at a suitable place with the attached nut.
4. Use the attached saddle to secure the end cap of the protective spiral tube. To
secure the protective spiral tube at a position other than the end cap, apply tape
to the tube so that the portion becomes thicker in diameter.
E39-F10 Fiber Connector
Fit the connector in the following procedure.
• The fiber units should be as close as possible when they are connected. Sensing
distance will be reduced by approximately 25% when fibers are connected.
Note: Only 2.2 mm dia. fibers can be connected.
Sticker
Attachment
Slit sticker
E32-T16 sensing head
Example
Protective Spiral
Tube
Fiber Unit
Protective Spiral
Tube
Fiber Unit
Protective
Spiral Tube
Toothed washer
Fiber Unit
Hexagon clamping nut
Mounting Panel
End cap
Tube
Saddle
Retention unit
Fiber Unit
Splice
Retention unit
Fiber Unit
Fiber Unit
Fiber Unit
AB
E56E-EN-04+FiberGuide+Datasheet.book Seite 51 Donnerstag, 22. Dezember 2011 1:38 13