Datasheet

11
1. Fasten the sensor temporarily.
3. Loosen the nut and adjust the distance.
2. Check the detection status with the
workpiece.
4. Finish by xing the nut.
Repeat steps
1 to 3 until
detection is
stabilized.
The HIGH SPEC Model’s sensing distance is approximately twice that of previous models. For example, the sensing distance of the quadruple distance model of M12 sized is 9 mm, which is about the same as
conventional M18 models. Using these sensors together with the e-jig allows you to easily upgrade your existing facilities so that you can replace their sensors in just 10 seconds.*
Easily upgrade existing facilities to enable “10-second* proximity sensor replacements”
A lot of time required to adjust to the optimum distance.
Adjustment position varies depending on the worker’s skill and
makes detection unstable.
1. Dismount the M18 proximity sensor from
the existing facility.
2. Mount an M18-sized e-jig. 3. Insert an E2E NEXT Series M12
Proximity Sensor into the e-jig.
8 mm
M18
Proximity sensor
M18
M12
9 mm
M18
e-jig
E2E NEXT
M12
* Time required to adjust the distance when installing a sensor.
Based on OMRON investigation.
Patent Pending
The O-ring blocks the ingress of foreign
matter, including cutting oil, into the e-jig
and ensures positioning precision (IP67G).
O-ring
O-r
ing
1. Insert the sensor into an e-jig.
2. Then just x the sensor.
Replacements in as little as 10 seconds* using e-jig
Using e-jig eliminates the need for adjustment so that anyone can install in the same position.
Replacement time reduced signicantly to approx.
10 sec.
*
Eliminating the need for adjustment allows for installation in the same position by any worker.
Previous
models
E2E NEXT