Datasheet

E2E2-X  Y  -M4 AC 2-wire Model
Applicable Models Pin Arrangement
E2E2-X  Y  -M4
Load
32
AC
 MOUNTING
Do not tighten the nut with excessive force. A washer must be used
with the nut.
Shielded Model Unshielded Model
Part B Part A
Part B Part A
Note: The table below shows the tightening torques for part A and
part B nuts. In the previous examples, the nut is on the sen-
sor head side (part B) and hence the tightening torque for
part B applies. If this nut is inpart A, thetightening torque for
part A applies instead.
Type
Torque
M12 30 N  m (310 kgf  cm)
M18 70 N  m (710 kgf  cm)
M30 180 N  m (1,800 kgf  cm)
Effects of Surrounding Metal
When mounting the E2E2 within a metal panel, ensure that the
clearances given in the table below are maintained. Failure to main-
tain these distances may cause deterioration in the performance of
the sensor.
ddia.
Type Item M12 M18 M30
E2E2-X  D  Shielded
 0mm 0mm 0mm


DC 2-wire
d 12 mm 18 mm 30 mm
D 0mm 0mm 0mm
m 8mm 20 mm 40 mm
n 18 mm 27 mm 45 mm
Unshielded
 15 mm 22 mm 30 mm
U
s
e
d
e
d
d 40 mm 70 mm 90 mm
D 15 mm 22 mm 30 mm
m 20 mm 40 mm 70 mm
n 40 mm 70 mm 90 mm
E2E2-X  B  Shielded
 0mm 0mm 0mm


E2E2-X  C 
D
C
3
w
i
r
e
d 12 mm 18 mm 30 mm
DC 3-wire
E
E
X

Y

D 0mm 0mm 0mm
E2E2-X  Y 
A
C
2
w
i
r
e
m 8mm 20 mm 40 mm
AC 2-wire
n 18 mm 27 mm 45 mm
Unshielded
 15 mm 22 mm 30 mm
d 40 mm 55 mm 90 mm
D 15 mm 22 mm 30 mm
m 20 mm 40 mm 70 mm
n 36 mm 54 mm 90 mm
E2E2 E2E2