Datasheet

XS5 NEXT Series

XS5 NEXT Series XS3XS5E2E/E2EQ NEXT Series DC 2-wire E2E/E2EQ NEXT Series DC 3-wire

Setup

• Do not install the Connectors with a load placed directly on the joint

or at the point where the wires connect to the Connector.

The Connector may be damaged or the wires in the cable may be

disconnected.

• If bending cables, ensure that these use a minimum bend radius of

40 mm.

Connecting

1. Connecting the XS5 Plug and Socket

• Align the projection on the plug cover with the polarity key on the

socket, then insert the plug all the way in.

• Hold the knurled socket grip, then insert the projection on the plug

into the groove of the socket.

• Turn the knurled grips of the socket clockwise approximately 1/8

turn in respect to the plug. A click will indicate that the Connectors

are locked. The locking condition can also be confirmed by the

alignment marks on the plug and socket.

2. Connecting the XS5 and XS2

• Align the projection on the plug cover with the polarity key on the

socket, then insert the plug all the way in.

• In the same way as when connecting two XS2 Connectors, screw

the knurled grip in the clockwise direction.

• When mating the products to XS2 or other M12 Connectors,

tighten the lock to a torque of 0.39 to 0.49 N

Please do not bend

from the root portion on the cable

Providing a straight section

from the root portion on the cable

The radius of

40 mm or more

Protrusion on

cover aligns with

polarity key.

Polarity key

Fixtures (grip)

Socket

Plug

Alignment marks