Datasheet

E2E
10
Safety Precautions
Refer to Warranty and Limitations of Liability.
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
• Do not short the load. Explosion or burning may
result.
• Do not supply power to the Sensor with no load,
otherwise Sensor may be damaged.
Do not use this product under ambient conditions that exceed the
ratings.
● Design
Influence of Surrounding Metal
When mounting the Sensor within a metal panel, ensure that the
clearances given in the following table are maintained. Failure to
maintain these distances may cause deterioration in the performance
of the Sensor.
〈Shielded Models〉
(Unit: mm)
〈Unshielded Models〉
(Unit: mm)
If mounted in a surrounding non-magnetic metal such as aluminum or copper, the sensing distance may shorten by about 40 to 50%.
If used in a recessed installation, take into consideration the effects of the material on the sensing distance.
Mutual Interference
When installing Sensors face-to-face or side-by-side, ensure that the minimum distances given in the following table are maintained.
Mutual Interference (Unit: mm)
* Values when the connector size is not taken into consideration.
WARNING
CAUTION
Precautions for Correct Use
Size
3 dia. 4 dia. 5.4 dia. 6.5 dia. M4 M5
Item
L 000000
m 353635
d 345.46.545
D 000000
n 810812810
c 000200
l
m
n
m
D
C
d dia.
l
Size
3 dia. 4 dia. 6.5 dia. M4 M5
Item
L 661266
m 69869
d 91224912
D 661266
n 16 20 24 16 20
l
m
n
m
D
d dia.
l
A
A
B
Size 3 dia. 4 dia. 5.4 dia. 6.5 dia. M4 M5
Item Shielded Unshielded Shielded Unshielded Shielded Shielded Unshielded Shielded Unshielded Shielded Unshielded
A 20 80 20 80 20 20 80 20 80 20 80
B * 15 60 15 60 15 15 60 15 60 15 60