Datasheet

G9SX-NS
14
Specifications
Non-contact Door Switch Controllers
Ratings
Power input
* Power consumption of loads not included.
Inputs
*1. Only applies to the G9SX-NSA222-T03-@. Refers to input other than that from the Non-contact Door Switch.
*2. Provide a current equal to or higher than that of the minimum applicable load of the connected input control device.
Outputs
*1. While safety outputs are in the ON state, the following signal sequence is output continuously for diagnosis.
When using the safety outputs as input signals to control devices (i.e. Programmable Controllers), consider the OFF pulse shown below.
*2. The following derating is required when Units are mounted side-by-side.
G9SX-NS202-@/G9SX-NSA222-T03-@: 0.4 A max. load current
Expansion Unit
Item Model G9SX-NS202-@ G9SX-NSA222-T03-@ G9SX-EX-@
Rated supply voltage 24 V DC
Operating voltage range −15% to 10% of rated supply voltage
Rated power consumption * 3 W max. 4 W max. 2 W max.
Item Model G9SX-NS202-@/G9SX-NSA222-T03-@
Safety input *1
Operating voltage: 20.4 VDC to 26.4 VDC, internal impedance: approx. 2.8 kΩ *2
Feedback/reset input
Item Model G9SX-NS202-@/G9SX-NSA222-T03-@
Instantaneous safety output *1
OFF-delayed safety output *1
P channel MOS FET transistor output
Load current: 0.8 A DC max. *2
Auxiliary output
PNP transistor output
Load current: 100 mA max.
Item Model G9SX-EX-@
Rated load 250 VAC, 3 A/30 VDC, 3 A (resistive load)
Rated carry current 3 A
Maximum switching voltage 250 VAC, 125 VDC
ON
OFF
360 μs max.
Approx.100 ms