Datasheet

CJ1 series CPU Units 175
Programmable
Controllers
Units of Width 31 mm
W, the total width is given by the following formula:
W = 80 (Power Supply Unit) + 62 (CPU Unit) + 20 x n + 31 x m + 14.7
(End Cover) (mm)
where n is the number of Units of width 20 mm and m is the number of
Units of width 31mm.
Example:For configurations with 2 32-point Basic I/O Units and 8 Units
of width 31 mm:
W = 156.7 + 20 x 2 + 31 x 8 = 444.7 mm
Mounting Dimensions Mounting Depth
The mounting depth of CJ-series CPU Racks and Expansion Racks
is from 81.6 to 89.0 mm depending on the Units that are mounted.
Additional depth is required to connect Programming Devices (e.g.,
CX-Programmer or Programming Console) and Cables. Be sure to
allow sufficient mounting depth.
Note: Consider the following points when expanding the configuration:
• The total length of I/O Connecting Cable must not exceed
12 m.
• I/O Connecting Cables require the bending radius indicated
below.
CS/CJ-series Connecting Cable
Unit Model number Width
I/O Interface Unit CJ1W-II101 31
8/16-point Basic I/O Units CJ1W-ID201/211
CJ1W-IA111/201
CJ1W-OD201/202/203/204
CJ1W-OD211/212
CJ1W-OC201/211
CJ1W-OA201
32-point Basic I/O Units CJ1W-MD231/232/233
64-point Basic I/O Units CJ1W-ID261/262
CJ1W-OD261/262/263
CJ1W-MD261/263/563
Interrupt Input Unit CJ1W-INT01
High-Speed Input Unit CJ1W-IDP01
Analog I/O Unit CJ1W-AD@@@
CJ1W-DA@@@
CJ1W-MAD42
Process Input Units CJ1W-PDC15
CJ1W-PTS15/16
CJ1W-PTS51/52
Temperature Input Units CJ1W-TS561/562
Temperature Control Units CJ1W-TC@@@
Position Control Units CJ1W-NC113/133
CJ1W-NC213/233
CJ1W-NC413/433
High-speed Counter Unit CJ1W-CT021
4-channel Counter Unit CJ1W-CTL41-E
SSI encoder Unit CJ1W-CTS21-E
Controller Link Unit CJ1W-CLK21
Serial Communications Unit CJ1W-SCU21-V1
CJ1W-SCU41-V1
Ethernet Unit CJ1W-ETN11/21
DeviceNet Unit CJ1W-DRM21
PROFIBUS-DP Units CJ1W-PRM21
CJ1W-PRT21
CAN Unit CJ1W-CORT21
RFID Sensor Units CJ1W-V600C11
CJ1W-V600C12
Position Control Unit CJ1W-NCF71
I/O Interface Unit 8/16-point Basic I/O Unit
and Interrupt Input Unit
Fujitsu connector
64-point Basic I/O Unit
Fujitsu connector
MIL connector
Special I/O Unit
/CPU Bus Unit
DIN rail model number A
PFP-100N2 16 mm
PFP-100N 7.3 mm
FPP-50N 7.3 mm
Approx. 100 to 150 mm
81.6 to 89.0 mm
R ≥ 69 mm
Note: Outer diameter of
cable: 8.6 mm.
Y201-EN2-03.book Seite 175 Donnerstag, 30. März 2006 1:52 13