Datasheet

27
A16
Removing the Lamp
(1) Removing from the Pushbutton End
(2) Removing from the Switch End
The Lamp can be removed by hand once the Switch is removed
using the A16Z-5080 Extractor.
Installing the Lamp
• When mounting the Lamp, make sure it is facing the direction
shown in the following diagram. Insert the Lamp while matching the
protruding part of the Lamp and the small guides on the outer
surface of the Case.
• The Lamp can be mounted from the Pushbutton end by using the
A16Z-5080 Extractor.
The lamp can be mounted by following the opposite procedure for
removing the Lamp.
Mounting the A16Z Dust Cover
Mounting the A16Z Switch Guard
Lamp
Grip the Lamp with the
A16Z-5080 Extractor
and pull to remove.
Protruding part
Mounting nut
Switch
Lock ring
Panel
Set
A16ZJ-5060
Cover A
(black)
Pushbutton Unit
Cover B
(transparent)
1. Separate the Dust Cover into 2 parts: cover A and cover B.
2. Insert the Case (Pushbutton Unit) into cover A.
3. Mount these parts together onto the panel.
4. From the back of the panel, mount the lock ring and secure with the
mounting nut.
5. Insert cover B into cover A. Ensure that the entire perimeter of cover B
is securely attached to cover A by pressing in different directions.
6. Mount the Switch to the Case.
Note: Recommended panel thickness: 0.5 to 2 mm.
Switch Guard
Switch
Mounting nut
Lock ring
Pushbutton Unit
Panel
1. Insert the Case (Pushbutton Unit) into the Switch Guard.
2. Mount these parts together onto the panel.
3. From the back of the panel, mount the lock ring and secure with the
mounting nut.
4. Mount the Switch to the Case.
Note: Recommended panel thickness: 0.5 to 2 mm.