Datasheet

227
Text
226
Text Surface-Mounting Signal Relay – G6K
G6K-2F-Y
G6K-2G-Y
G6K-2P-Y
Mounting Dimensions (Top View) Terminal Arrangement/
Internal Connections
(Top View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Mounting Dimensions (Top View) Terminal Arrangement/
Internal Connections
(Top View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Tolerance: ±0.1 mm
Tolerance: ±0.1 mm
Mounting Dimensions (Bottom View) Terminal Arrangement
/
Internal Connections
(Bottom View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Eight, 0.8-dia. holes
Tolerance: ±0.1 mm
3.5
G6KU-2F-Y
G6KU-2G-Y
G6KU-2P-Y
Mounting Dimensions (Top View)
Terminal Arrangement/
Internal Connections
(Top View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Mounting Dimensions (Top View) Terminal Arrangement/
Internal Connections
(Top View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Tolerance: ±0.1 mm
Tolerance: ±0.1 mm
Mounting Dimensions (Bottom View) Terminal Arrangement
/
Internal Connections
(Bottom View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Eight, 0.8-dia. holes
Tolerance: ±0.1 mm
3.5
Signal Relays
Surface-Mounting Signal Relay – G6K
■
DPDT
Must Operate and Must Release
Time Distribution
(see note)
G6K-2G (F/P), G6K-2G (F/P)-Y
Number of contacts
Sample: G6K-2G
Number of Relays:
50
Time (ms)
Sample: G6K-2G
Number of Relays: 50
Change rate on the basis of rated value (%)
After test
Must Operate and Must Release
Bounce Time Distribution
(see note)
G6K-2G (F/P) , G6K-2G (F/P)-Y
Vibration Resistance
G6K-2G (F/P), G6K-2G (F/P)-Y
Number of contacts
Note: The tests were conducted at an ambient temperature of 23°C.
Must operate
bounce time
Must operate voltage
Must release voltage
Time (ms)
Must release
bounce time
Must operate
Must release time
G6K-2F
Mounting Dimensions (Top View)
Terminal Arrangement/
Internal Connections
(Top View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
G6K-2G
Mounting Dimensions (Top View) Terminal Arrangement/
Internal Connections
(Top View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Tolerance: ±0.1 mm
Tolerance: ±0.1 mm
G6K-2P
Mounting Dimensions (Bottom View)
Terminal Arrangement
/
Internal Connections
(Bottom View)
Orientation mark
Note: Each value has a tolerance of ±0.3 mm.
Eight, 0.8-dia. holes
Tolerance: ±0.1 mm
3.5
Dimensions
Note: 1. All units are in millimetres unless otherwise indicated.
Omron 08 Cat 1-302 5/10/07 15:39 Page 226