Datasheet

ManualsBrandsOmron Electronic Components ManualsAngle & Rotary SensorsTilt Sensor, 80°, Resistive

D7E Sealed Vibration Sensors and Tilt Sensor

D7E

■ Dimensions (Unit: mm)

D7E-@

■ Safety Precautions

• If the mounting surface is not level, deformation from mounting

may adversely affect operating characteristics.

Do not use a mounting surface with warpage of more than 0.3

mm. Use M3 mounting screws and tighten them to 0.39 to

0.59 N·m.

Use washers or other means to prevent loosening of the

screws when mounting.

• Do not subject the Sensor to direct sunlight.

• Also, OMRON is not responsible for the deterioration of func-

tions caused by washing with water, submersion in water, oil

leaks, or contact with organic solvents.

• Do not use the Sensor in any location where vibration would

adversely affect the operating acceleration or other mechani-

cal characteristics (such as locations affected by opening and

closing of doors, locations with passing vehicles, or other loca-

tions that are subject to vibration or shock from equipment or

other sources).

2.9

36.4

23.6

(31.1)

23.6 dia.

22 dia.

(9.5)

23.1

5.3

2.3

2-#187 tab/soldering

terminal (thickness: 0.5)

4.8

5.95.9

Four, 12.85 radius

Four, 1 radius

R3.4

+0.15

−0.05

3.1

+0.15

−0.05

4 dia.

6.4

(developed length)

dia.

3.1

Two, M3 holes

Mounting Hole Dimensions

Note: Mounting Procedure

Pitch: 30 mm, two M3 mounting

screws, product height at

mounting screw section: 5.3 mm

Mounting directions: horizontal (less than ±0.5°)

Electronic and Mechanical Components Company

Regional Contact

Cat. No. A217-E1-03

0919(1014)(O)

Americas Europe

https://www.components.omron.com/ http://components.omron.eu/

Asia-Pacific China

https://ecb.omron.com.sg/ https://www.ecb.omron.com.cn/

Korea Japan

https://www.omron-ecb.co.kr/ https://www.omron.co.jp/ecb/

In the interest of product improvement, specifications are subject to change without notice.