Datasheet

5
B5W-LD0101-1/2
Dimensions (Unit: mm)
Air Quality Sensor
Mounting Conditions
The recommended dimensions for the suction inlet and exhaust outlet of the Air Quality Sensor are as follows.
Secure the spaces shown in the figure.
50
1
2
× 3
24.5
17
3
1.3
±0.2
46
37
2×13.8
52.3
0.3
8.5
39.3
0.3
41.6
6 or less
Mounting range
Center of exhaust
outlet
16
1.6
Heater
Center of
suction inlet
(1)(2)(3)(4)(5)
B5W-LD0101-1/2
Unless otherwise specified, the
tolerances are as shown below.
Note: Dimensions in parentheses
are for reference only.
Dimensions Tolerance
3 mm max. ±0.20
3 < mm ≤ 6 ±0.24
6 < mm ≤ 10 ±0.29
10 < mm ≤ 18 ±0.35
18 < mm ≤ 30 ±0.42
30 < mm ≤ 50 ±0.50
50 < mm ≤ 80 ±0.60
Pin
Terminal
name
Remarks
(1) V
CC Input voltage pin
(2) V (OUT1) Output voltage pin 1
(3) GND Ground pin
(4) Vth Input threshold voltage pin
(5) V (OUT2) Output voltage pin 2
Connector on circuit board side: AMP 292164-5
Number of terminals: 5 pin
Recommended mating connectors: AMP173977-5
10 or more
Unit: mm
10 or more
Align this surface
with the exterior
of the sensor
10 or more
Align this surface
with the exterior of
the sensor
Align with the center of
the sensor opening
Align with the center of
the sensor opening
<Exhaust outlet>
<Suction inlet>
Note1: Ensure that the suction inlet and exhaust outlet are as close to the sensor case
in the forward and rear directions as possible
Note2: Install to the flat part using an M3 screw with a tightening torque of 0.54 N·m or less.
25 or more