Datasheet

9
B5T Human Vision Components (HVC-P2)
B5T
Connector Pin Assignment
CN5: Provides power and the UART communication interface.
Board-side connector: SM06B-SRSS-G-TB (made by J.S.T. Connectors, recommended for use)
Housing: SHR-06V-S-B or SHR-06V-S (made by J.S.T. Connectors)
Contact: SSH-003GA-P0.2 (made by J.S.T. Connectors)
* Do not make the RX terminal floating when applying power to the Device.
Note: Do not use CN3 and CN5 simultaneously.
Mounting Method
Note 1: This figure is for a frontal mounting direction (0°) of the module.
Settings need to be changed through commands when mounting the Device at a clockwise rotation angle of 90°, 180° or 270° from the front.
Note 2: Fix each board with the M2 screws in the four board corner holes.
Make sure not to bend or break the board when fastening the screws.
Apply torque appropriately for the screws used.
Note 3: Make sure to fix the board so that it is not warped, bent or any under unreasonable stress.
Note 4: Make sure that the board is sufficiently distanced from any electrically-conductive part.
Note 5: Take proper measures against static electricity.
Pin number Signal I/O Description
1 Vcc - Power supply 5.0 V ±10%
2 UART RX * Input
UART [receive] (Device  Host)
Logic 0: 0 V Logic 1: 3.3 V
3 UART TX Output
UART [send] (Host  Device)
Logic 0: 0 V Logic 1: 3.3 V
4 GND - Ground
5 RESET Input
Reset signal (Device  Host)
Logic 0: 0 V Logic 1: 3.3 V
Reset is active on logic 0
6 RESERVED - Do not connect to this
2.1
2.5
2.1 dia.
2.3 dia. 2.3 dia.
Four, 2.2 dia.
Main board
Camera board