User's Manual

V740 RFID READER/WRITER, ANTENNA 2005-07, REV.01
OPERATION MANUAL
7 of 45 ©OMRON CORPORATION 2005
One to four OMRON Bi-static antennas(V740-HS02C)
can be connected to the reader, depending on the
application requirements. The upper row silk-screen
markings on the reader identifies the port number and
antenna connections.
Antenna Connections : V740-BA50C24-US
A
ntenna x4
(V740
-
HS01L
，
V740
-
HS01C)
Note: Lower row of silk-screen marking on the reader
is reserved for future use.
Antenna Cable x8
(
V740-A01
)
Note: When two antenna configuration, there are
possibility to read the tag by not activated antenna
when the tag is located proximately (within 20cm).
1. Connect required UHF antennas to the antenna
ports on the reader .
IMPORTANT: Connect antennas to the antenna
ports before applying power to the reader. Any
antenna port not having an antenna connected to
it will be disabled when the reader is powered on.
2. Verify that all antennas are securely connected.
3. Connect the reader to the network by plugging a
Shielded Ethernet cable into the Ethernet port.
or
Connect the reader to a PC (personal computer)
by plugging a crossover Shielded Ethernet cable
into the Ethernet port.
Antenna Connection : V740-BA50C04-US
Antenna x2
(V740
-
HS01L
，
V740
-
HS01C)
Note: If DHCP is to be used, then the network
and server must be connected before powering
up the reader. If a DHCP server is not found the
reader will fall back to the IP address:
“10.0.0.101”.
Note: If NTP is to be used, then the network must
be connected and the server must be available
before powering up the reader. If a NTP server is
not found. The reader will not set the current time.
Antenna Cable x4
(
V740-A01
)
4. Plug the power adapter provided with the reader
into the DC power input connector. Then connect
the power cord to a power outlet.
While the reader is powering up, one green light
will be on. After the reader finishes its power-on
self-test, approximately 45 seconds, the green
light will pulse. The reader is now ready for
operation.