User's Manual

V740 RFID READER/WRITER, ANTENNA 2005-07, REV.01
OPERATION MANUAL
6 of 45 ©OMRON CORPORATION 2005
Mechanical Loading - Mounting of the equipment in
the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
1.3 Reader Installation
The following parts are provided with the reader:
Part Qty. Part Number
V740-Reader/Writer 1
V740-BA50C04-US or
V740-BA50C24-US
Power Supply 1 -
1.3.2 Install the Antennas
The antennas can be mounted directly to a variety of
surfaces. Mounting surfaces should be flat to fix the
antenna securely.
IMPORTANT: Be sure the user reads the section on
Declarations to maintain compliance with FCC
regulations. The Reader and the antennas are to be
installed only by professionals at specific locations For
human safety maintain a 23 cm (9.1in) distance from
the antennas .
To mount the reader on a wall :
1. Hold the antenna in its mounting location and
mark the position of the mounting screws with
minimum (4) points. The antenna has several
mounting holes for each side. Choose 4 of those
with diagonal position according to the mounting
location.
1.3.1 Install the Reader
You can place the reader on a shelf or mount it to a
wall. Mounting shelf and wall should be flat to fix the
reader securely.
To mount the reader on a wall:
1. Hold the reader in its two mounting location and
mark the position of the mounting screws
2. Drill holes for the screws and install wall anchors if
required.
3. Insert the M4x20 screws with spring washers and
flat washers and tighten until almost flush with the
wall.
4. Tighten the screws securely.
Mounting
holes
Note: For best performance, mount the antenna in
the horizontal orientation as pictured above.
1.3.3 Connect the Reader
2. Drill holes for the screws and install wall anchors if
required. Be sure anchors must have enough
strength to fixed the reader against vibration.
A B C D E
A = RJ-45 Ethernet port 10/100Base-T
B = Safe Mode button
C = RS232C (Reserved for future use)
D = GPIO
E = DC power input
3. Insert the M5x16 screws with spring washers and
flat washers and tighten until almost flush with the
wall.
4. Slip the reader over the screws and slide down to
lock the screws in the keyhole openings.
5. Tighten the screws securely.
6. Fix the AC adaptor so that not to move by
vibration and tense DC plug cables. Do not bundle
the adaptor cable with other signal or power lines.