User's Manual

V740 RFID READER/WRITER, ANTENNA 2005-07, REV.01
OPERATION MANUAL
16 of 45 ©OMRON CORPORATION 2005
Restart Page
Firmware Upgrade Page
Use the Restart page to restart the reader.
Use the Firmware upgrade page to update firmware.
Only the update firmware file provided by OMRON
can be used.
1. Click the Restart link on the navigation menu. The
Restart Reader page appears.
2. To restart the reader, click the Restart System
button. The following dialog box appears.
1. Click the Firmware link on the navigation menu.
The Firmware upgrade page appears.
2. Place the cursor in the Filename field and type
the complete network pathname of the firmware
file or click the Browse button to locate the new
firmware file.
3. Click OK. The following message appears and
remains on the screen until the reader restarts.
Then the Status page appears.
3. Be sure to click both check boxes if you want the
reader to revert to safe-mode settings(Ref. section
1.5.3.).
The lower check box becomes enabled after
clicking the check box above.
4. Click the Upgrade button to download the new
firmware to the reader.
The status frame at the bottom of the page
displays the progress of the upgrade if the web
browser supports automatic page reload. Click the
Refresh button to update the status bar if the web
browser does not support automatic page reload.
The firmware downloaded to the reader IS NOT
implemented until the reader is restarted.
If an error occurs during the firmware upgrade,
use Safe Mode to recover.
IMPORTANT: DO NOT disconnect power from the
reader while the firmware is being updated. You may
get unpredictable results.