User's Manual

V740 RFID READER/WRITER, ANTENNA 2005-07, REV.01
OPERATION MANUAL
15 of 45 ©OMRON CORPORATION 2005
Device and LAN settings
Item Describe Setting
Requirement
Default
Device Settings
UHF Power (dBm)
UHF Output power in dBm. This setting must be adjusted
carefully to comply with FCC regulations.
Mandatory 30.0
Class 1 96-bit
Support
Radio button that enables 96-bit tag support. To optimize
the reader keep this setting turned off unless it is needed.
- ON
Hostname Specify a name that is unique on the network for the
reader.
Mandatory mercury4
NTP Server Specify the IP address (or machine name) of the server to
get current time from the network (either LAN or WAN). The
reader obtains correct time from another device since it
doesn't have a hardware clock.
Example) 129.6.15.8(NIST, Gaithersburg, Maryland)
Optional (none)
Domain Name Specify the group name when using devices on the network
as a group. Omit unless using devices as a group.
Optional (none)
Primary DNS
Server
Specify the IP address (or machine name) of the server
that replaces a domain name with an IP address on the
network. It is used at first, the secondary DNS server is
used next. Omit if you access by the static IP address.
Optional 10.0.0.1
Secondary DNS
Server
Specify the IP address (or machine name) of the server
that replaces a domain name with an ID address.The
server is used only when the primary DNS server can not
find the domain name. Omit if you access by the static IP
address.
Optional (none)
Default Gateway Select whether the reader uses LAN wired or air interface. - LAN(fixed)
LAN TCP/IP Settings
Use DHCP Select whether the reader gets an IP address on the
network automatically by DHCP or manual setting. You
must not check the item if you use a manually set IP
address.
Optional Yes
Vendor Class
Identifier
Specify an extra DHCP parameter for integration and
customization. It is not supported on the firmware version
2.0.61.
Optional mercury4
Use DHCP Server
Supplied
Hostname
Set this to yes to allow the DHCP server to assign the
reader a hostname.
- No
LAN IP Address Specify a unique IP address on the network when manually
set. It is given automatically by the DHCP server, if using
DHCP.
Mandatory (in
the case of not
using DHCP)
10.0.0.101
LAN Netmask Specify the mask value to determine the network address
of the subnet from the IP address. It is not used if using
DHCP.
Mandatory (in
the case of not
using DHCP)
255.255.255.0
LAN Gateway Specify a unique IP address for the gateway machine only
when communicating with the device on another LAN. You
don't have to set the item when communicating with the
device on the same LAN. Also It is not used if using DHCP.
Optional (in the
case of not using
DHCP)
10.0.0.1