User's Manual

V740 RFID READER/WRITER, ANTENNA 2005-07, REV.01
OPERATION MANUAL
14 of 45 ©OMRON CORPORATION 2005
Settings Page
Use the Modify Settings page to change network
settings.
1. Click the Settings link on the navigation menu.
The Modify Settings page appears.
2. Enter the required settings.
3. Click the Save Changes button to save the new
settings.
IMPORTANT: Do not disconnect power until the
save process is complete.
The new settings DO NOT take effect until the
reader is restarted by rebooting the reader
(see 1.5.2 Restarting the Reader on page 15).
Instructions for Modifying the Settings
Changing these parameters changes the readers
settings used on startup. Both radio settings and
network settings can be modified. Care must be
taken to use correct values or you might be unable to
connect the reader without restarting into safe mode.
Static network settings are ignored when in DHCP
mode, and DHCP related settings are ignored when in
static IP mode. Please note that your network needs
to have properly configured DNS servers if you wish
to connect to the reader via its hostname. Usually
when using DHCP, the DHCP server will add the
hostname to the DNS server’s database.
The reader adjusts time by NTP only once when it
starts up.You should confirm if the time is correct
using Get information command(Ref. Section
2.2.4.4).
Note: Please ask the network administrator about the
network settings in your environment.