User's Manual

4-6 Wiring Method
4-6
4-19
5) Soldering
Soldering iron to use Conductor cross-sectional area (mm
2
)
30W 0.5
6) Reassemble the connector as follows.
(1) Put the coupling nut with directing its thread to the connecting
side over the barrel.
(2) Screw the end bell and torque it to the specified values.
(3) Tighten the setscrew to the specified torque value.
(4) Tighten the clump nut to the specified torques value and attach
the clamp saddle to the end bell.
• Tightening torque for screws Unit:N•m
End bell 1.0 - 1.5
Clamp nut 0.4 - 0.6
Set Screw 0.2 - 0.3
Connector models
Model name of connector plug for host communications: NJC-165-PM from Nanaboshi Electric Mfg. Co., Ltd.
Model name of I/O connector plug: NJC-2010-PM from Nanaboshi Electric Mfg. Co., Ltd.
Before use, be sure to check for the proper torques of the cable of your choice. OMRON does not offer any guarantee
for customer-made cables. Please inquire to the manufacturer for details of these connectors.
(1) Insert the pre-soldered wire into the solder pot of the contact.
(2) Heat the contact and the conductors with a soldering iron.
(3) Pour solder to fill the opening between the contact and the
conductors.
Clamp nut
Clamp saddle
End bell
Coupling nut
Barrel
Setscrew
Solde
r
Wire
Contact
Iron tip
Conductor