User's Manual

5-7 Setting Command
5-7
5-62
5-7-15 Chip Operating Mode Switch (TY)
This command changes the operating mode (ISO/I.CODE1) of the Reader/Writer.
 <Command Format>
STX Node No..
Command code
“TY”
Tag
type
ETX
BCC
1 2 2 1 1 1
Tag type Specifies the mode.
0: I.CODE1 mode
1: ISO mode
When the Operating Mode is set to "**," the Operating Mode currently
set in the Reader/Writer will be read.
  <Response Format>
STX Node No.. Retry
flag
Command code
“TY”
Response
code
“00”
Tag
type
ETX BCC
1 2 1 2 2 1 1 1
Response code 00:normal completion
For other Response Codes, refer to SECTION 5-3-7 Response Code List.
Tag type Specifies the mode.
： The setting is enabled after reset by the Reset Command. To enable the setting forthe next
start-up, the setting must be saved by Set Value Writing (EW).