Manualshelf

User's Manual

ManualsBrandsOmron Corporation, RFID Business Development Department ManualsElectronicsRF ID Reader
121122123124125126127128129130
5-7 Setting Command
5-7
5-60
5-7-12 Offline Mode Setting (FL)
This command selects whether the Reader/Writer will start in online mode or offline mode.
When offline mode is selected, the Reader/Writer will perform EAS check independent of the
host, and output a signal from the output port (OUT1) if the result exceeds the specified
criterion.
<Command Format>
STX Node No. Command
code
"FL"
On/OFF
mode
Time Threshold ETX BCC
1 2 2 1 2 2 1 1
Specify the number corresponding to the mode in which the
Reader/Writer will start.
Specification range: 0, 1, *
When “* “is specified, the Reader/Writer reads the current setting.
Specification
number
0 1 *
On/OFF mode
On/OFF mode Online mode Offline mode -
Time (*100ms) Specify the length of time in HEX for which the signal will be output to
OUT1 in offline mode.
Specification range: 01 to FFh (100ms to 22.5s)
When “**” is specified, the Reader/Writer reads the current setting.
Threshold (%) Specify the threshold in HEX to be output to OUT1 in offline mode.
Specification range: 00h to 64h (%)
(Refer to EAS Check Command.)
When “**” is specified, the Reader/Writer reads the current setting.
<Response Format>
STX Node No. Retry
flag
Command
code
"FL"
Response
code:
"00"
On/OFF
mode
Time Threshold ETX BCC
1 2 1 2 2 1 2 2 1 1
Response code: 00: Normal completion
For other response codes, refer to 5-3-7 Response Code List.
On/OFF mode Indicates the number corresponding to the specified On/Off mode.
Time Indicates the time corresponding to the specified On/Off mode.
Threshold Indicates the criterion corresponding to the specified On/Off mode.
Notes on the execution of Offline Mode Setting Command
● The setting is enabled after reset by Reset Command (XZ).
● To enable the setting at the next startup, the setting must be saved in the non-volatile memory
(EEPROM) on the Reader/Writer using Set Value Writing (EW).
● To enable EAS on the Tag, use System Write (SW) in ISO Mode, or EAS Setting (ES) in I.CODE1
Mode. The command related to this is the EAS Setting(ES) and EAS Check(EA).