User's Manual

5-7 Setting Command
5-7
5-57
<Response Format>
STX Node No. Retry
flag
Command
code
"CP"
Response
code:
"00"
Port
No.
Baud
rate
Data
length
Parity
bit
Stop
bit
BCC
Enabled
/Disabled
ACK
NACK
Time
out
ETX BCC
1 2 1 2 2 1 1 1 1 1 1 1 1 1 1
Response code: 00: Normal completion
For other Response Codes, refer to Response Code List.
Port No. Indicates the number corresponding to the specified terminal resistance.
Baud rate Indicates the number corresponding to the specified baud rate.
Data length Indicates the number corresponding to the specified data length.
Parity bit Indicates the number corresponding to the specified parity bit.
Stop bit Indicates the number corresponding to the specified stop bit.
BCC
Enabled/Disabled
Indicates the number corresponding to the specified BCC setting.
ACK/NACK Indicates the number corresponding to the specified control mode.
Timeout Indicates the number corresponding to the specified timeout period.
：・The setting is enabled after reset by the Reset Command(XZ). To enable the setting forthe
next start-up, the setting must be saved by Set Value Writing (EW).