User's Manual

5-7 Setting Command
5-7
5-52
5-7-1 Reader/Writer AFI Enable/Disable Changeover (AE): ISO Mode only
In ISO mode, you must set AFI of the Reader/Writer either enable or disable when communicating with a
Tag. If you set AFI enable, only Tags, which has the same AFI, can be communicated. When you set AFI
disable, the communications are enabled no matter AFI in Reader/Writer is set or not.
<Command Format>
STX Node No..
Command code
“AE”
AFI
Setting
ETX
BCC
1 2 2 1 1 1
AFI
enable/disable
Specifies either valid or invalid of AFI setting in Reader/Writer.
0: disabled (factory setting)
1: enabled
For “*”, the Reader/Writer reads and writes current settings.
<Response Format>
STX Node No..
Retry
flag
Command code
“AE”
Response
code
“00”
AFI
Setting
ETX
BCC
1 2 1 2 2 1 1 1
Response code 00:normal completion
For other Response Codes, refer to SECTION 5-3-7 Response Code List.
AFI valid/invalid Indicates valid/invalid of AFI in hexadecimal.
： ・A setting becomes valid after executing Reset Command(XZ). To keep the setting valid next
startup, you need to save with Setting Write Command(EW).
・This command is for ISO Mode Only. The command is not available in I.CODE1 mode.
5-7-2 Reader/Writer AFI Value setting (AF): ISO Mode only
In ISO mode, you must set and read AFI of the Reader/Writer. When you set AFI enable, only Tags, which
has the same AFI, can be communicated. When the setting is “00”, the communications are enabled.
<Command Format>
STX Node No..
Command code
“AF”
AFI
ETX
BCC
1 2 2 1 1 1
FI Specifies AFI in hexadecimal.
Specification range:00h to FFh (factory setting “00”)
For “**”, the Reader/Writer reads and writes current setting of AFI.
<Response Format>
STX Node No..
Retry
flag
Command code
“AF”
Response
code
“00”
AFI
ETX
BCC
1 2 1 2 2 1 1 1
Response code 00: normal completion
For other Response Codes, refer to SECTION 5-3-7 Response Code List.
AFI Specifies AFI in hexadecimal.
：・A setting becomes valid after executing Reset Command. To keep the setting valid next
startup, you need to save with Setting Write Command (EW).
・This command is for ISO Mode Only. The command is not available in I.CODE1 mode.