User manual

00043092.DOC, Version 2.0
25/31
5 INSTALLATION
The PM-3010 can be used as a table top unit or it can be installed into a console. Please make sure that
there is enough space around the unit for ventilation to improve heat dissipation. Steady overheating will
d
amage the unit.
Switch off the mixer prior to connecting any units or to changing any existing connections.
1 Connect the stereo audio sources to the corresponding RCA jacks (white jack = left; red jack = right):
• The jacks MAIN INPUTS CH-1 to CH3 are assigned to the channels 1-3 and allow for connecting units
with line level output e.g. CD players or turntables. If your turntable is equipped with a separate ground
lead, connect it to the corresponding clamping screw GND.
• The jacks AUX 1 to 4 can be freely assigned to each channel and allow for connecting units with line
level output e.g. CD players or tape decks.
• Aux and mic input sources are freely assignable to each channel. For creative mixing, the same source
may be assigned to several channels.
2 You can connect three microphones: a DJ microphone to the DJ microphone channel DJ MIC and two
further microphones to the microphone channels MIC 1 and MIC 2.
• Connect a DJ microphone via an XLR plug or a 6.3 mm plug to the front input DJ MIC
• Two further microphones can be connected via 6.3 mm plugs to the rear inputs MIC 1 and MIC 2 and
can be freely assigned to each channel.