User manual

00026738.DOC, Version 1.1
13/15
Front panel
1 2 3 4 5 6 7
(1) POWER SWITCH with POWER-LED
Press this button to start operating.
(2) LINE-CONTROL
With this control, you can adjust the LINE level.
(3) STEREO-/MONO-BUTTON
Pressed button: Mono-mode
Unpressed button: Stereo-mode.
(4) SIGNAL-LED
This LED lights up as long as a signal is present at the input.
(5) CLIP-LED
The Clip-LED flashes when the output signal starts distorting.
(6) MONO-LED
The MONO-LED flashes when the respective zone is in MONO-mode.
(7) LINE-LED
This LED lights up as long as a signal is present at the input.
Rear panel
8
9 10
R
L
22222
2
111 11
1
230V
50Hz
FUSE
T500mA
INPUT
ZONE1
ZONE2
ZONE4
ZONE5
Z
ONE6
ZONE3
11
(8) INPUT-SOCKETS
Balanced XLR input sockets.
(9) ZONE-OUTPUT SOCKETS 1-6
Balanced XLR output sockets.
(10) AC CONNE CTION
Plug the power supply cable in here.
(11) FUSEHOLD ER
By turning the fuseholder, you can switch the device from 115 V to 230 V.
INSTALLATION
Rack mounting
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the front panel and the rear panel. The rack should be provided with a cooling fan.
When mounting the device into the rack, please make sure that there is enough space around the device so
that the heated air can be passed on. Steady overheating will damage your device.
You can fix the device with four screws M6 in the rack.