Datasheet

TRAFFIC MANAGEMENT
■ IEEE 802.1Q VLAN tagging and 802.1ad Q-in-Q VLAN
stacking
■ Service Multiplexing of up to 256 EVCs
■ User-congurable EtherType
■ Ingress and Egress trafc management
■ CIR/EIR Color Aware “two rates, three colors” bandwidth
proles for ingress rate limiting
■ Advanced Flow and CoS classication per Port, VLAN ID,
PCP, IPv4/IPv6 (TOS/DiffServe) Priority, MAC address, IP
address, TCP Port or L2CP
■ Layer 2 Protocol Tunneling (L2PT) to encapsulate STP,
VTP, PVST and CDP protocols (subscriber CISCO
protocols)
■ All ports congurable as UNI or NNI
■ IEEE 1588v2 Compliant transparent clock mode
■ 10,240 byte Jumbo frames
PROTECTION AND REDUNDANCY
■ ITU-T G.8031 Ethernet Linear Protection Switching
■ ITU-T G.8032v2 Ethernet Ring Protection Switching with
multi-ring protection and sub-ring support
■ Sub-50ms failover for G.8031 and G.8032v2
■ Link Failover 50ms protection switching
■ Rapid Spanning Tree
■ Link modes for port-to-port and UNI-to-UNI failure
propagation
INTERFACES
■ 10/100/1000BASE-T Copper and 100/1000BASE-X SFP
ber
■ Small Form Pluggable (SFP) transceivers for standard or
CWDM applications
■ Port Mirroring
SERVICE OAM AND TESTING
■ IEEE 802.1ag End-to-End Connectivity Fault
Management (CFM) – with 8 Maintenance Domain levels
and 256 Maintenance Associations
■ Supports IEEE 802.1ag Maintenance Intermediate Points
(MIPs) for fault isolation
■ ITU-T Y.1731 End-to-End Performance Monitoring
■ Hardware-based Delay and Loopback measurement with
nanosecond resolution
■ Advanced classication and ltering of Layer 1, 2, 3 or 4
subscriber trafc as an EVC or CoS ow
■ ITU-T Y.1731 threshold monitoring and threshold
crossing alerts
■ IEEE 802.3ah Ethernet Link OAM with dying gasp
■ Zero-Touch Provisioning
■ DEMARC Auto-Conguration (DAC) for DPoE Networks
■ ITU-T Y.1564 Ethernet Service Activation testing with
multi-ow testing of information rate, latency, jitter and
frame loss
■ RFC 2544 built-in test-head with wire-speed, per ow
testing of throughput, latency, jitter and loss
■ ITU-T Y.1564 and RFC 2544 test heads support
generation/reception of in-service and out-of-service L2,
L3 and L4 frames
■ Test-heads with congurable rate-limiting to isolate
provisioning and network issues
■ Per-port and per-ow Loopback with MAC swap
■ Compatible with third party in-band loopback testing
■ Built-in UTP cable tester for troubleshooting through to
the Customer Equipment
NETWORK MANAGEMENT
■ Remote management via TELNET, SSH, SNMPv1/v2c/v3
■ SNMP management via Omnitron’s NetOutlook Network
Management software
■ IP-less management through 802.3ah OAM extensions
■ Fully integrated with Cyan CyPortal for SLA monitoring
■ MEF 30 and 31 Service OAM Fault Management MIBs
Page 3
iConverter GM4