iConverter User Manual

L2CP Control - iConverter GX/TM2 iConverter, Serial Agent

Identifier -

Chassis Number = 1 Slot Number = 1 Model Number = 8939N-0

1: Fiber L2CP Ingress Control Forward

2: UTP L2CP Ingress Control Forward

Enter Choice, Previous Screen(0), (H)elp, E(x)it >

Select the appropriate option to configure the module for the desired operation.

4.2.4 SFP Information

The GX/TM2 module installed with an SFP will provide general and specific information on the SFP. This

information is best viewed with SNMP management software. The following is the information available:

4.2.4.1 SFP A0 Information Display

This section displays fixed SFP Module information for the following areas.

• Identifier Values • Extended Identifier

• Connector Values • Transceiver Codes

• Encoding Rules • Normal Bit Rate

• Link Length • Vendor Name

• Vendor OUI • Vendor Revision Number

• Laser Wavelength • Options

• Vendor Serial Number • Date Code

• Diagnostic Monitoring Type • Enhanced Options

• SFF-8472 Compliance

4.2.4.2 SFP A2 Information Display

This section displays decoded SFP data collected for the following statistics.

• Measured Temperature • Measured Vcc

• Measured Bias • Measured Tx Power

• Measured Rx Power • Temperature High Alarm Setting

• Temperature Low Alarm Setting • Temperature High Warning Setting

• Temperature Low Warning Setting • Vcc High Alarm Setting

• Vcc Low Alarm Setting • Vcc High Warning Setting

• Vcc Low Warning Setting • Bias High Alarm Setting

• Bias Low Alarm Setting • Bias High Warning Setting

• Bias Low Warning Setting • Tx Power High Alarm Setting

• Tx Power Low Alarm Setting • Tx Power High Warning Setting

• Tx Power Low Warning Setting • Rx Power High Alarm Setting

• Rx Power Low Alarm Setting • Rx Power High Warning Setting

• Rx Power Low Warning Setting

SFP information can be obtained by selecting option 7 from the Port configuration screen.

Page 31