Media Converter User Manual

To change the ingress rate of the UTP port, select option 6.
Change UTP CIR (range 64 to 100000)> 100000
To change the egress rate, select option 4 for the fiber port or option 9 for the UTP port. The egress rates are
displayed. Select the desired egress rate.
PI SA
Bandwidth Control - iConverter 10/100M2 iConverter, Serial Agent
Identifier -
Chassis Number = 1
Slot Number = 1
Model Number = 8919N-0
1: 64 Kbps 11: 6 Mbps
Fiber Controls 2: 128 Kbps 12: 7 Mbps
-------------------------------------- 3: 256 Kbps 13: 8 Mbps
1: Ingress CIR 100000 kbps 4: 512 Kbps 14: 9 Mbps
2: Ingress CBS 150 kB 5: 768 Kbps 15: 10 Mbps
3: Excess Traffic Policy Drop 6: 1 Mbps 16: 20 Mbps
4: Egress rate 100 Mbps 7: 2 Mbps 17: 30 Mbps
5: Queueing Fair Weight 8: 3 Mbps 18: 40 Mbps
9: 4 Mbps 19: 50 Mbps
UTP Controls 10: 5 Mbps 20: 100 Mbps
--------------------------------------
6: Ingress CIR 100000 kbps
7: Ingress CBS 150 kB
8: Excess Traffic Policy Drop
9: Egress rate 100 Mbps
10: Queueing Fair Weight
Select Fiber Egress Rate from menu above (1-20) >
4.3.3 Layer 2 Control Protocol Filter
Layer 2 Control Protocol Filter provides the ability to discard, forward or tunnel L2CP frames based on the
network requirements. Select ‘discard’, ‘forward’ or ‘tunnel’.
The Layer 2 Control Protocol Filter is accessed by selecting option 9 from the Port configuration screen.
PI SA
L2CP Control - iConverter 10/100M2 iConverter, Serial Agent
Identifier -
Chassis Number = 1 Slot Number = 1 Model Number = 8919N-0
1: Global L2CP Control Forward
Enter Choice, Previous Screen(0), (H)elp, E(x)it >
Select the appropriate option to configure the module for the desired operation.
Page 29