Media Converter and Network Interface Device User Manual

4.3.10 Port Statistics
The 10/100M module provides port statistics on both the fiber and UTP port.
The Port Statistics can be viewed by selecting option P from the Module configuration screen.
Module - iConverter 10/100M iConverter, Serial Agent
Identifier -
Chassis Number = 1 Switch ON Condition OFF Condition H/W Actual
Slot Number = 1 1: Pause Enabled Pause Disabled Off Off
Model Number = 8919-0 2: Fiber HDX Fiber FDX Off Off
3: UTP Manual UTP Auto-Neg Off Off
Serial Number = xxxxxxxx 4: UTP 10 Mbps UTP 100 Mbps Off Off
Manufacturing Date = xxxxxxxx 5: UTP HDX UTP FDX Off Off
Product Revision = x 6: Link Propagate Link Segment Off Off
Software Revision = xx 7: Remote Fault Normal Off Off
8: Symm Fault Det Normal Off Off
LED 9: BP A Enabled BP A Disabled On On
1: Power = On 10: BP B Enabled BP B Disabled On On
2: Power Supply 1 = Off 11: Not Available
3: Power Supply 2 = Off 12: Slave Only Master/Slave Off Off
4: Power Supply 3 = Off 13: Not Available
5: Fiber Link = Off 14: Not Available
6: BP Master = On 15: Not Available
7: UTP 10 Link = Off 16: Not Available
8: UTP 100 Link = Off OAM settings:
9: UTP FDX = Off 17: IP Protocol State On
18: Management Mode Secure OAM
Toggle Switch(1-16), (I)dentifier, (R)eset, (H)elp, (P)ortStat, Port(C)tl > P
Port Statistic
Module - iConverter 10/100M iConverter, Serial Agent
Identifier -
Chassis Number = 1
Slot Number = 1
Model Number = 8919-0
Port Statistics
-------------------------------------------
Fiber UTP
Rx Bytes 0 0
Rx Packets 0 0
Rx Total Packets 0 0
Tx Bytes 0 0
Tx Packets 0 0
Enter Choice, Previous Screen(0), (H)elp, E(x)it >
To refresh the Port Statistic screen, press <ENTER>.
Page 43