Media Converter and Network Interface Device User Manual

4.3.1 Port Access
The Port Access option allows the ports to be disabled/enabled while maintaining the port configuration
and network link
To configure Port Access, select option 1 for the Fiber port and option 2 for the UTP port from the Port
configuration screen.
4.3.2 Bandwidth Control
The 10/100M Bandwidth Control is accessed by selecting options 21 - 24 or 14 - 17 depending on the
module type; plug-in or standalone.
The 10/100M provides separate ingress and egress rate control on each port.
Ingress values will be displayed when the option is selected. Values of 128Kbps, 256Kbps, 512Kbps,
1Mbps, 2Mbps, 4Mbps, 8Mbps and Full bandwidth are available.
Egress values will be displayed when the option is selected. Values of 128Kbps, 256Kbps, 512Kbps,
1Mbps, 2Mbps, 4Mbps, 8Mbps and Full bandwidth are available.
Module - iConverter 10/100M iConverter, Serial Agent
Identifier -
Chassis Number = 1 Port VLAN Path Setup
Slot Number = 11 ----------------------------------
Model Number = 8919-0 11: Fiber to UTP Enable On
12: Fiber to BP A Enable On
Port Access Control Setup 13: Fiber to BP B Enable On
---------------------------------- 14: UTP to BP A Enable On
1: Fiber Enable On 15: UTP to BP B Enable On
2: UTP Enable On 16: BP A to BP B Enable On
17: Fiber to Mngmnt Enable On
Enhanced Features 18: UTP to Mngmnt Enable On
---------------------------------- 19: BP A to Mngmnt Enable On
3: 802.1Q Processing Enable Off 20: BP B to Mngmnt Enable On
4: Configure Tag VLAN Control
5: Configure VLAN Membership Bandwidth Control
6: Save TAG VLAN parameters --------------------------------
7: Configure 802.3ah parameters 21: Ingress rate Fiber No Limit
8: Configure 802.3ah events 22: Egress rate Fiber No Limit
9: SFP Information 23: Ingress rate UTP No Limit
10: cNode Loopback 24: Egress rate UTP No Limit
Enter Choice, Previous Screen(0), (H)elp, E(x)it >21
New Rate (0= No Limit, 1=128Kbps, 2=256Kbps, 3=512Kbps,
4=1Mbps, 5=2Mbps, 6=4Mbps, 7=8Mbps) > 0
Page 29