Media Converter and Network Interface Device User Manual

4.3 PORT CONFIGURATION
The Port configuration screen provides access to the port level configuration parameters, such as, Port
Access, Bandwidth Control, SFP information, 802.3ah, Port VLANs, Tagged VLANs and cNode Loopback.
To access the Port configuration screen, select C from the Module configuration screen and press <ENTER>.
The Port configuration screen will appear.
Module - iConverter 10/100M iConverter, Serial Agent
Identifier -
Chassis Number = 1 Port VLAN Path Setup
Slot Number = 11 ----------------------------------
Model Number = 8919-0 11: Fiber to UTP Enable On
12: Fiber to BP A Enable On
Port Access Control Setup 13: Fiber to BP B Enable On
---------------------------------- 14: UTP to BP A Enable On
1: Fiber Enable On 15: UTP to BP B Enable On
2: UTP Enable On 16: BP A to BP B Enable On
17: Fiber to Mngmnt Enable On
Enhanced Features 18: UTP to Mngmnt Enable On
---------------------------------- 19: BP A to Mngmnt Enable On
3: 802.1Q Processing Enable Off 20: BP B to Mngmnt Enable On
4: Configure Tag VLAN Control
5: Configure VLAN Membership Bandwidth Control
6: Save TAG VLAN parameters --------------------------------
7: Configure 802.3ah parameters 21: Ingress rate Fiber No Limit
8: Configure 802.3ah events 22: Egress rate Fiber No Limit
9: SFP Information 23: Ingress rate UTP No Limit
10: cNode Loopback 24: Egress rate UTP No Limit
Enter Choice, Previous Screen(0), (H)elp, E(x)it >
Module - iConverter 10/100M iConverter, Serial Agent
Identifier -
Chassis Number = 1 Port VLAN Path Setup
Slot Number = 11 ----------------------------------
Model Number = 8919-0 11: Port1 to Port2 Enable On
12: Port1 to Mngmnt Enable On
Port Access Control Setup 13: Port2 to Mngmnt Enable On
----------------------------------
1: Fiber Enable On Bandwidth Control
2: UTP Enable On --------------------------------
14: Ingress rate Fiber No Limit
Enhanced Features 15: Egress rate Fiber No Limit
---------------------------------- 16: Ingress rate UTP No Limit
3: 802.1Q Processing Enable Off 17: Egress rate UTP No Limit
4: Configure Tag VLAN Control
5: Configure VLAN Membership
6: Save TAG VLAN parameters
7: Configure 802.3ah parameters
8: Configure 802.3ah events
9: SFP Information
10: cNode Loopback
Enter Choice, Previous Screen(0), (H)elp, E(x)it >
Page 28