Manual

iConverteriConverter
®
Multiplexes up to sixteen independent T1 or E1 circuits ■
from copper links onto one ber link
10/100/1000 copper Ethernet service multiplexed with ■
T1/E1 circuits
Small Form Pluggable (SFP) or xed ber transceivers, ■
in standard and CWDM wavelengths
Supports multimode, single-mode dual ber and single- ■
mode single-ber
Remotely-managed conguration and testing enables ■
rapid deployment
Management via local serial port, Telnet, or SNMP ■
Congurable alarm relay contacts for audio/visual fault ■
notication
Supports local and remote ber and copper loop-back ■
modes
Commercial (0 to 50º C ) and wide (-40 to 60º C) ■
operating temperature ranges
Lifetime Warranty and free 24/7 Technical Support ■
iConverter T1/E1 MUX/M
Managed T1/E1 Multiplexer
The iConverter T1/E1 MUX/M multiplexes up to sixteen T1 or
E1 circuits and one 10/100/1000 Ethernet service onto a ber
optic transport link, and features remotely managed testing
and conguration capabilities.
The iConverter T1/E1 MUX/M operates in a back-to-back
conguration, and can be used in applications such as multiple
T1/E1 extension, mobile backhaul and building-to-building
PBX connectivity.
The T1/E1 copper interfaces are available in 4, 8, 12 or 16
RJ-48 port congurations for balanced T1/E1 applications.
Optional adapter cables are available to convert each RJ-
48 interface to a BNC interface for unbalanced E1 transport
applications.
Additional hot-swappable 4-Port T1/E1 MUX modules can
be installed to increase system capacity up to 16 T1/E1 ports
maximum per 1U (1.75 inch) chassis.
The T1/E1 MUX/M is available with xed-ber or Small Form
Pluggable (SFP) transceivers, enabling easy adaptability to
different ber types, distances and wavelengths. The T1/E1
MUX/M supports multimode, single-mode, single-mode single-
ber in standard (850nm, 1310nm and 1550nm) and CWDM
wavelengths.
The T1/E1 MUX/M features user-selectable local loop-back
on both the copper and ber ports, remote ber loop-back
and circuit test modes. These features facilitate testing of
the remote unit, and minimize the need for test equipment
and support personnel. Alarm relays and LEDs provide fault
notication for loss of power, LOS and AIS.
Conguration of T1/E1 line codes, line build out, loopbacks
and circuit test is accomplished via local serial port, Telnet,
SNMP, or DIP-switches.
The 1U high iConverter T1/E1 MUX/M chassis can be mounted
in a 19-inch or 23-inch rack and features two load-sharing
power supplies. It supports hot-swappable universal AC,
24VDC or 48VDC power supplies for power redundancy.
Key Features