- Omnitron Systems Technology, Inc. Media Converter and Network Interface Device User Manual

To change the ingress rate of the Port 1, select option 1.
Change Fiber CIR (range 64 to 100000)> 142
To change the ingress rate of the Port 2, select option 6.
Change Port 2 CIR (range 64 to 100000)> 100000
To change the egress rate, select option 4 for Port 1 or option 9 for the Port 2. The egress rates are
displayed. Select the desired egress rate.
PI SA
Bandwidth Control - iConverter 2FXM2 iConverter, Serial Agent
Identifier -
Chassis Number = 1
Slot Number = 1
Model Number = 8959N-0
1: 64 Kbps 11: 6 Mbps
Port 1 Control 2: 128 Kbps 12: 7 Mbps
-------------------------------------- 3: 256 Kbps 13: 8 Mbps
1: Ingress CIR 100000 kbps 4: 512 Kbps 14: 9 Mbps
2: Ingress CBS 150 kB 5: 768 Kbps 15: 10 Mbps
3: Excess Traffic Policy Drop 6: 1 Mbps 16: 20 Mbps
4: Egress rate 100 Mbps 7: 2 Mbps 17: 30 Mbps
5: Queueing Fair Weight 8: 3 Mbps 18: 40 Mbps
9: 4 Mbps 19: 50 Mbps
Port 2 Control 10: 5 Mbps 20: 100 Mbps
--------------------------------------
6: Ingress CIR 100000 kbps
7: Ingress CBS 150 kB
8: Excess Traffic Policy Drop
9: Egress rate 100 Mbps
10: Queueing Fair Weight
Select Fiber Egress Rate from menu above (1-20) >
4.3.3 Layer 2 Control Protocol Filter
Layer 2 Control Protocol Filter provides the ability to discard, forward or tunnel L2CP frames based on the
network requirements. Select ‘discard’, ‘forward’ or ‘tunnel’..
The Layer 2 Control Protocol Filter is accessed by selecting option 9 from the Port configuration screen.
PI SA
L2CP Control - iConverter 2FXM2 iConverter, Serial Agent
Identifier -
Chassis Number = 1 Slot Number = 1 Model Number = 8959N-0
1: Global L2CP Control Forward
Enter Choice, Previous Screen(0), (H)elp, E(x)it >
Select the appropriate option to configure the module for the desired operation.
Page 28