- Omnitron Systems Technology, Inc. Media Converter and Network Interface Device User Manual

When the upload is complete, the 2FXM2 displays the update status and then automatically restarts with
the newly loaded firmware.
3.4.4.4 Updating the 2FXM2 Firmware via FTP
Using an FTP application, upload the new firmware into the FTP root directory of the 2FXM2. When the
file transfer is complete, the 2FXM2 verifies the file and then automatically restarts with the newly loaded
firmware.
For detailed instructions on updating the management modules and other modules in the same chassis via
FTP, download the application note “iConverter Management: Updating Modules via FTP” available on
Omnitron’s web page:
http://www.omnitron-systems.com/downloads.php
See Setting 2FXM2 Passwords Section 3.4.1.4, on how to configure FTP.
3.5 VERIFY OPERATION
PI SA
Once the module has been installed and configured, per Sections 3.2 - 3.4, verify the module is operational
by viewing the status of the LED indicators. The table below provides a description for each LED indicator.
The Power LED indicates the modules is receiving power from the chassis or power cord. The plug-in
modules has an LED indicator for each available power supply in the chassis (the 19-Module Chassis has
three, the 5-Module Chassis has two).
The Fiber Optic LEDs (“P1” and “P2”) indicate the fiber optic connection has been established. A blinking
LED indicates the presence of data.
Refer to Section 6.0, Troubleshooting Guide, for help in determining possible fault conditions.
PI SA
PI SA
LED Function
"Legend"
Color Off State
On / Blinking State On / Blinking State
Power "Pwr" Green No power On: Module has power On: Module has power
Power Supply Status
#X
Green
Chassis Power
Supply not installed
On: Power available from
installed Power Supply #X
Blinking: No power available
from installed Power Supply #X
Not available on standalone
Port 1
Fiber Link Activity
"P1"
Green No Fiber Link
On: Fiber link is active
Blinking: Fiber Data Activity
On: Fiber link is active
Blinking: Fiber Data Activity
Port 1
Half/Full Duplex
"FDX"
Green Half-Duplex On: Full-Duplex On: Full-Duplex
Chassis Management
Master/Slave
"Msr/Slv"
Green
Chassis Slave
Mode
On: Chassis Master
Blinking: Operating in OAM
Mode
Not available on standalone
Port 2
Fiber Link Activity
"P2"
Green No Fiber Link
On: Fiber link is active
Blinking: Fiber Data Activity
On: Fiber link is active
Blinking: Fiber Data Activity
Port 2
Half/Full Duplex
"FDX"
Green Half-Duplex On: Full-Duplex On: Full-Duplex
Page 21