User guide

1U 19” Rack Mount Shelf
User Manual
PRODUCT OVERVIEW
The 1U 19” rack mount shelf accommodates iConverter standalone media converters,
iConverter 1-Module chassis, iConverter 2-Module chassis and OmniConverter media
converters. Up to four iConverter standalone modules can be mounted to the shelf. Up to
three OmniConverters and/or iConverter 1-Module and up to two iConverter 2-Module
Chassis can be mounted to the shelf.
1U Rack Mount Shelf
INSTALLATION PROCEDURE
1) Unpack, Visual Inspection and Inventory
2) Rack Mounting
3) General Installation
4) Installing iConverter Standalone Wall Mount Modules to the Shelf
5) Installing iConverter 2-Module Chassis to the Shelf
6) Installing OmniConverter and iConverter 1-Module Chassis to the Shelf
7) Installing Assorted Units to the Shelf
1) UNPACKING, VISUAL INSPECTION AND INVENTORY
Review the contents. The following items should be included:
1U Rack Mount Shelf • User Manual•
20 Small Plastic Snap Rivets • 20 Large Plastic Snap Rivets•
(For mounting holes B & D) (For mounting holes A & C)
2) RACK MOUNTING
Mount and attach the shelf to the 19” standard rack using the appropriate rack mounting
screws (not included).
When rack-mounting the shelf, the rack should be appropriately earthgrounded.
The shelf provides NEBS ground posts to secure a grounding lug and wire from the rack to
the ground post.
7) INSTALLING ASSORTED UNITS TO THE SHELF
Any three types of assorted units can be mounted to the shelf.
In order to mount the module/chassis to the shelf, make sure the proper wall mount brackets
(not included) are installed on the module/chassis.
Shelf with Assorted Units
NOTE: Mounting the 2-Module chassis to the shelf requires 2U rack spacing.
WARRANTY
This product is warranted to the original purchaser against defects in material and workmanship for a period of
TWO YEARS from the date of shipment. A LIFETIME warranty may be obtained by the original purchaser by
REGISTERING this product with Omnitron within 90 days from the date of shipment. TO REGISTER, COMPLETE
AND MAIL OR FAX THE ENCLOSED REGISTRATION FORM TO THE INDICATED ADDRESS. Or you may
register your product on the Internet at http://www.omnitron-systems.com. During the warranty period, Omnitron
will, at its option, repair or replace a product which is proven to be defective.
For warranty service, the product must be sent to an Omnitron designated facility, at Buyer’s expense. Omnitron
will pay the shipping charge to return the product to Buyer’s designated US address using Omnitron’s standard
shipping method.
Limitation of Warranty
The foregoing warranty shall not apply to defects resulting from improper or inadequate use and/or maintenance
of the equipment by Buyer, Buyer-supplied equipment, Buyer-supplied interfacing, unauthorized modications
or tampering with equipment (including removal of equipment cover by personnel not specically authorized and
certied by Omnitron), or misuse, or operating outside the environmental specication of the product (including
but not limited to voltage, ambient temperature, radiation, unusual dust, etc.), or improper site preparation or
maintenance.
No other warranty is expressed or implied. Omnitron specically disclaims the implied warranties of merchantability
and tness for any particular purpose.
Exclusive Remedies
The remedies provided herein are the Buyer’s sole and exclusive remedies. Omnitron shall not be liable for any direct,
indirect, special, incidental, or consequential damages, whether based on contract, tort, or any legal theory.
040-08260-001A 6/10
Page 1
Omnitron Systems Technology * 140 Technology Dr. #500 * Irvine, CA 92618
949.250.6510 tel * 949.250.6514 fax * www.omnitron-systems.com