Instruction Manual

2.2 Module Installation
The iConverter 1-Module Redundant chassis supports a variety of managed
and unmanaged iConverter modules. When installing a module into the chassis,
carefully slide the module into the open slot. Align the module with the installation
guides and ensure that the module is firmly seated against the backplane.
Secure the module by fastening the front panel thumbscrew (push in and turn
clockwise to tighten) to the chassis front.
Figure 1: Module Installation
Note: iConverter plug-in modules are hot-swappable and can be installed into
any chassis in the iConverter family. For additional information regarding
iConverter module installation, please consult the specific module’s user manual.
2.3 Fiber Installation
Connect an appropriate multimode or single-mode fiber cable to the fiber port
of the installed module. It is important to make sure that the transmit (TX) is
attach to the receive side of the device at the other end and the receive (RX) is
attach to the transmit side.
Single-fiber (SF) media converter models operate in pairs. The TX wavelength
must match the RX wavelength at the other end and the RX wavelength must
match the TX wavelength at the other end.
For additional information regarding iConverter module fiber installation, please
consult the specific module’s user manual.
Page 5