Instruction Manual

The table describes the function of each switch.
hctiwS-PID
noitisoP
noitcnuFetatSnoitacidnIgnitropeR
11mralA
delbasiD=nwoDgnitropermralaoN
delbanE=pUnoitacidnimralalenaptnorF
22mralA
delbasiD=nwoDgnitropermralaoN
delbanE=pUnoitacidnimralalenaptnorF
33mralA
delbasiD=nwoDgnitropermralaoN
delbanE=pUnoitacidnimralalenaptnorF
44mralA
delbasiD=nwoDgnitropermralaoN
delbanE=pUnoitacidnimralalenaptnorF
Table 4: Contact Sensors - DIP-switch Configuration
NOTE: Not all chassis are equipped with the contact sensors. Internally, all
signal return (“Rt”) pins are connected.
The 8-pin connector has the following pin configuration:
#niPnoitpircseD)egatlovwol(tiucriCdesolC)egatlovhgih(tiucriCnepO
1)"+"(1rosneSmralAoNmralA
2)"tR"(nruteRlangiS
3)"+"(2rosneSmralAoNmralA
4)"tR"(nruteRlangiS
5)"+"(3rosneSmralAoNmralA
6)"tR"(nruteRlangiS
7)"+"(4rosneSmralAoNmralA
8)"tR"(nruteRlangiS
Table 5: Contact Closure Sensors Pinout Configuration
Page 13