FlexSwitchTM 8U Model 6700-FK Replacement Kit User Manual 140 Technology #500, Irvine, CA 92618 Phone: (949) 250-6510; Fax: (949) 250-6514
Table of Contents 1.0 1.1 2.0 2.1 2.2 2.4 3.0 3.1 3.2 3.3 3.3.1 4.0 4.1 5.0 INTRODUCTION .................................................................... 3 General Description ............................................................. 3 INSTALLATION ...................................................................... 3 Chassis Installation .............................................................. 3 Module Installation ...............................................................
2.4 3.2 UTP Installation DC Powered Chassis Mounting Connect the UTP port via a Category 5 cable to a 10Base-T or 100Base-Tx Ethernet device. • Locate the DC circuit breaker, and switch the circuit breaker to the OFF position. 3.0 CONFIGURATION • 3.1 DC Powered Chassis Site Preparation Prepare a power cable using a three conductor insulated wire (not supplied) with a 14 AWG gauge minimum. Cut the power cable to the length required.
3.3 Configuring the DIP-Switches UTP 10/100Mbps “10/100” DIP-Switch (Port 1 or Port 2) The 6700-FK has been pre-configured with Auto-Negotiation enabled for plug and play ease of use. However, the iConverter Switch Modules offer additional configuration flexibility. 3.3.1 Switch Module Each 4-Port Switch Module has been pre-configured for Auto-Negotiation. On-board DIP-Switches are available to manually configure Port 1 and 2 of each module. The figure indicates the factory default settings.
4.0 LED INDICATORS 4.1 Switch Module 5.0 Each 4-Port Switch Module has LED indicators to provide connection information. SPECIFICATIONS Description 8 Port 10/100 Auto-Sensing Switch Protocols 10Base-T, 100Base-Tx, with 1536 bytes max. frame size UTP Cable Type EIA/TIA 568A/B Category 5 and higher UTP Connector Type RJ45 DIP-Switches UTP Port 1 and 2: AN/MAN, 10/100, FD/HD Power Requirements +/- 18 to 60VDC -48VDC @ 1.0A Dimensions W:6.7" x D:5.51" x H:1.
Warning The operating description in this Instruction Manual is for use by qualified personnel only. To avoid electrical shock, do not perform any servicing of this unit other than that contained in the operating instructions, unless you are qualified and certified to do so by Omnitron Systems Technology, Inc. Caution All user-required operations can be performed without opening the unit. Never attempt to open or remove the cover or tamper with the unit.
