User Manual

ManualsBrandsOmnitron Systems Technology ManualsCommunicationFlexPoint Powered Chassis 14-slot power-redundant chassis

Omnitron Systems Technology, Inc.

140 Technology Drive #500 Irvine, CA 92618

(949) 250-6510; Fax: (949) 250-6514

FlexPoint

Powered Chassis

AC Power-Redundant

14-Module Chassis

User’s Manual

8 Omnitron Systems Technology, Inc.

SPECIFICATION

 Indicators:

Power ON: LED (2), Yellow, power applied

 Dimensions / Weight: W:19.0"xD:7.0"xH:3.5" / 9 lb.

 Power: 110 / 230 VAC, 50 / 60 Hz

 Environmental:

Temperature: 0 to 50 degrees C

Humidity: 5-95% (non-condensing)

TECHNICAL SUPPORT

If you encounter problems in installing this product, contact Omnitron Tech Support:

Phone: (949) 250-6510

Fax: (949) 250-6514

Address: Omnitron Systems Technology, Inc.

140 Technology Drive, #500

Irvine, CA 92618, USA

E-mail: support@omnitron-systems.com

URL: http://www.omnitron-systems.com

040-04395-002C 1/09

Summary of content (4 pages)

PAGE 1
8 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc. SPECIFICATION Indicators: Power ON: Dimensions / Weight: Power: Environmental: Temperature: Humidity: LED (2), Yellow, power applied W:19.0"xD:7.0"xH:3.5" / 9 lb. 110 / 230 VAC, 50 / 60 Hz 0 to 50 degrees C 5-95% (non-condensing) TECHNICAL SUPPORT If you encounter problems in installing this product, contact Omnitron Tech Support: Phone: (949) 250-6510 Fax: (949) 250-6514 Address: Omnitron Systems Technology, Inc.
PAGE 2
Omnitron Systems Technology, Inc. Safety Considerations Warning The operating description in this Instruction Manual is for use by qualified personnel only. To avoid electrical shock, do not perform any servicing of this unit other than that contained in the operating instructions, unless you are qualified and certified to do so by Omnitron Systems Technology, Inc. Caution All user-required operations can be performed without opening the unit.
PAGE 3
6 Omnitron Systems Technology, Inc. Omnitron Systems Technology, Inc.3 The Powered Chassis is intended to be used with two power supplies in a power-redundant operation. A failure of a single supply should not disturb the operation of the chassis unit. However, certain power supply failures may cause a secondary failure to the associated fan and cause undesired overheating of the chassis unit.
PAGE 4
Omnitron Systems Technology, Inc. CONTROLS AND INDICATORS LEDs Display: The Powered Chassis features two LEDs on the left front of the chassis, these LEDs display the status of the two power supplies. Omnitron Systems Technology, Inc. 5 UNPACKING a. Visual Inspection: Inspect equipment in order to detect any physical damage. Any evidence of damage should be noted and reported immediately.