User Manual

AN-013-A OPS241 Code Update OmniPreSense Corporation 6
Figure 10. Completed Programming
Step 8. Once the board is reprogrammed it’s ready to use. The Memtool will leave the board in a reset
state. Unplug the board from the USB port and disconnect the JTAG connector on J6.
You can check the programming was successful by plugging the board back into the USB port on the PC
and using Tera Term to validate the new code is programmed and runs. Start Tera Term and it will
automatically detect which port the board is connected to. Select the Serial button with the proper port
selection. You should see speed data (m/s) start to stream from the board while waving your hand above
the board. Press ?? to report the board information and note the Version number is correct for the
expected code which has been programmed (Figure 11).
Figure 11. Programmed Board Validation