INSTALLATION AND ASSEMBLY INSTRUCTIONS ALL DIMENSIONS ‐ MM (INCH) MODEL : PANA103PRO MAX LOAD CAPACITY : 500 LB (227 KG) DOCUMENT NO : IA‐PANA103PRO_REV.
INSTALLATION AND ASSEMBLY INSTRUCTIONS ALL DIMENSIONS ‐ MM (INCH) MODEL : PANA103PRO MAX LOAD CAPACITY : 500 LB (227 KG) NOTE : READ ENTIRE INSTRUCTION SHEET BEFORE YOU START INSTALLATION AND ASSEMBLY WARNING • • • • • • Do not begin to install your Panasonic product until you have read and understand all instructions and warnings contained in this Installation Sheet. If you have any questions regarding any instructions and/or warnings please call Panasonic Customer Support.
INSTALLATION AND ASSEMBLY INSTRUCTIONS ALL DIMENSIONS ‐ MM (INCH) MODEL : PANA103PRO MAX LOAD CAPACITY : 500 LB (227 KG) INSTALLATION TO THE WALL WARNING • • Installer must verify that the supporting surface will safely support four (4) times the combined weight of all attached equipment (wall mount) and hardware along with panel. Mount is only meant for surface mounting to a wall. For recessed mounting or any other mounting please contact Omnimount Customer Service.
INSTALLATION AND ASSEMBLY INSTRUCTIONS ALL DIMENSIONS ‐ MM (INCH) MODEL : PANA103PRO MAX LOAD CAPACITY : 500 LB (227 KG) • Remove spacers from rear of screen. Retain four (4) 16MM screws for installation of Panel Brackets. • Secure Panel Brackets (C) to rear of screen by using the original 16MM screws along with four (4) Flat Washers (I) and four (4) Locking Washers (J). CAUTION • Ensure that each fastener is tight and secure prior to preparing panel to lift and hang in position.
INSTALLATION AND ASSEMBLY INSTRUCTIONS ALL DIMENSIONS ‐ MM (INCH) MODEL : PANA103PRO MAX LOAD CAPACITY : 500 LB (227 KG) WARNING • Ensure that all adjustments are made with proper support of the panel at all times. No adjustments should be made unless done by a qualified installation professional. TILT ADJUSTMENT • • • • • Remove the lower bolt shown in Fig. 1 (Factory installation is set at 0° tilt) NOTE: Retain all hardware for installation after tilt position is selected.
INSTALLATION AND ASSEMBLY INSTRUCTIONS ALL DIMENSIONS ‐ MM (INCH) MODEL : PANA103PRO MAX LOAD CAPACITY : 500 LB (227 KG) LATERAL ADJUSTMENT • • • Ensure that the panel is properly supported during lateral adjustment. Lift the panel per Panasonic lifting requirements to remove the load from the installed components. The panel may be shifted from side to side for final positioning and then set back into the retaining slots of the wall bracket.
