Installation Guide

6
Flat Panel
4
3: Attaching the clips
a. Using a Phillips head screwdriver,
thread the wall screws through
the clips into the wall anchors.
Note: Do not use power tools to
install these screws. Hand tighten
only. Do not over tighten, as
damage may occur.
4: Running your cables and attach
the cable covers
a. Run your cables through the
grooves in the clips.
b. Press the cable covers firmly
against the clips and reconnect
your cables.
Optional: Installing the bottom cover
a. Slide the bottom cover over the
last cable cover. Ensure the
grooves on the bottom cover line
up with the ridges on the cable
cover.
English
Flat Panel
3 Optional