Installation Guide

5
Consult a qualified
installer if you
have any questions
regarding the proper
installation of this wall
mount system.
IMPORTANT
Installation Instructions
Installation Instructions
Flat Panel
Mounting with Screws
1: Determine your desired cable
management position
a. Hold one of the straight cable
covers against the wall and, with
a pencil, mark the center of the
cover on the wall.
b. Using a level and a pencil, extend
the center point line 56mm on
each side (112mm total).
c. Using a level, extend the lines
down the wall.
2: Drill your holes
a. Hold two clips against the wall
in your desired position. With a
pencil, mark where the lines you
drew are visible through the screw
holes on the clips.
b. Using a 1/4” (5.5mm) drill bit, drill
the four pilot holes and insert the
wall anchors.
c. Each cable cover will use two
clips, so, with a level, continue to
extend the lines until all clips have
holes drilled in the wall.
English
Flat Panel
Flat Panel
2
1