Installation & Assembly

800 Glen Avenue • Moorestown, N.J. 08057
800.257.2326 • FAX: [phone]
www.omnimedbeam.com
Instruction Sheet
CPU Holder
0311.AS.OMNI
Use the provided security screw
wrench to loosen the Top Cover
off the CPU Holder
Loosen the CPU Slide screw and adjust
the width of the slides to match your
PC. Loosen the screws holding the side
slide in place. Place your CPU on the
base and position the slides closely
around it. Remove the CPU and tighten
the slide screws. Replace the CPU and
secure it in by retightening the Top Cover.
Your Transport Stand is now fully
assembled and ready for use.
CPU Slide Screw
Side Slide Screws