MiniEMBWiFi Embedded controller V2.5 1.
WIFI part------introduction 1.Connect to WIFI with a Cable: ① Switch on the WIFI of the portable power device ② Plug in the cable from the router ③ Turn on the WIFI of the cellphone and connect to wifi_xxxxxx (6 random numbers ) √ Connection is completed and the Internet is accessable. No setting is needed as default. If the setting is changed, enter the Internet setting in the WIFI navigation page, select Dynamic Acquisition as the WAN connection mode. 2.
4.U-disk Share (Android OS): ① Switch on the WIFI of the portable power device ② Turn on the WIFI of the cellphone and connect to wifi_xxxxxx (6 random numbers ) ③ Plug in the U-disk to the device ④ Open the ES document browser; click Local; click Share ( If it's the first you use, you need to click Creat; click the Server; input 192.16.10.1, with admin as username and password, click OK Click 192.16.10.
6.IP dial-up: ① Switch on the WIFI of the portable power device ② Plug in the cable from ADSL ③ Turn on the WIFI of the cellphone and connect to wifi_xxxxxx (6 random numbers ) ④ Open the cellphone's browser; input 192.168.10.
FCC Statemant This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
